Design Related Question Answers

1. This is a thin solid line directing attention to a note or dimension and starting with an arrowhead or dot:






2. When positioning this feature of perspective projection, the centerline of the cone of visual rays should be directed toward the approximate center of the object:






3. Two-point perspective is also known as:






4. How can the drafter prevent AutoCAD from placing or stacking another center mark on a circle when adding a diameter dimension to it?






5. Given a situation in which the drafter has crossed extension lines in a drawing what can be done to clean up the point of crossing?






6. Switches and relays should be shown in this position with no operating force or applied energy:











7. This is the intersection of the ground plane with the picture plane:






8. This is used to indicate that a surface is to be machined:






9. These items typically are not used in new designs, but are still common in high-power amplifiers:






10. The ________ tool on the Dimension tool bar will place several dimensions at one time by using a selection box placed over several part features.






11. This is a line terminated by arrowheads, indicating the direction and extent of a dimension:






12. One way to evenly space dimensions on a drawing is to use the ________.






13. Baseline dimensions are referenced from a common geometric feature known as a ________.






14. These are special installations of stone or concrete marking the locations of points accurately determined by precise surveying:






15. This type of circuit is a semiconductor wafer or chip:






16. Perspective drawings are classified according to their number of these features:






17. These are lines drawn on a map to locate, in the plan view, points of equal ground elevation:






18. The ________ tool on the Dimension tool bar places the length of an arch on a drawing.






19. The condition of a part when it contains the least amount of material is referred to as ________.






20. These maps are used in planning installations of trees, shrubbery, drives, and other garden features:






21. This type of drawing is created to calculate areas, locate property lines, and locate building projects and facilities:






22. These are accurately drawn maps of cities and towns showing property lines and other features that control property ownership:






23. In U.S. structural and architectural drafting, all dimensions of this length are usually expressed in feet and inches:






24. In this type of dimensioning, allowance must be made for bends:






25. This is the total amount that the feature on the actual part is allowed to vary from what is specified by the dimension:






Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions